14.31. taler-exchange-router(1)

14.31.1. Name

taler-exchange-router - route purse payments to partner exchanges

14.31.2. Synopsis

taler-exchange-router [-c FILENAME | –config=FILENAME] [-h | –help] [-L LOGLEVEL | –loglevel=LOGLEVEL] [-l FILENAME | –logfile=FILENAME] [-T USEC | –timetravel=USEC] [-t | –test] [-v | –version]

14.31.3. Description

taler-exchange-router is a NOT YET IMPLEMENTED command-line tool to route P2P payments to partner exchanges via wad transfers. This will be needed if wallet-to-wallet payments are made between wallets where the recipient has performed the KYC at a different exchange than the sender. This is currently not supported.

-c FILENAME | –config=FILENAME
Use the configuration and other resources for the exchange to operate from FILENAME.
-h | –help
Print short help on options.
-L LOGLEVEL | –loglevel=LOGLEVEL
Specifies the log level to use. Accepted values are: DEBUG, INFO, WARNING, ERROR.
-l FILENAME | –logfile=FILENAME
Send logging output to FILENAME.
-T USEC | –timetravel=USEC
Modify the system time by USEC microseconds. USEC may be prefixed with + or - (e.g. -T +300). This option is intended for debugging/testing only.
-t | –test
Run in test mode and exit when idle.
-v | –version
Print version information.

14.31.4. See Also

taler-exchange-expire(1), taler-exchange-httpd(1), taler.conf(5).

14.31.5. Bugs

Report bugs by using https://bugs.taler.net/ or by sending electronic mail to <taler@gnu.org>.